Chronic jumpers can be a danger to other dogs, people, and themselves. The No Jump Harness will discourage this habit. It works by restricting dog's back legs from fully flexing. He will be able to walk but not jump or run. Reinforced box stitching and sturdy nylon makes harness extra durable. Rustproof safety catches and clips are easy to adjust. Harness measures 3/4 inches wide and over 5 feet long - you adjust the length for the proper fit. For dogs between 10 and 80 pounds. Leash (not included) attaches to ring located at top of harness. Collar not required. Available in black.
Please click on "More Information" for instructions for use.
Instructions:
Lay the No Jump Harness out on the floor or table and familiarize yourself with all of the parts. Do not unbuckle or remove any straps until asked to do so in these instructions. Locate the neck area at the black buckle, the back area at the red buckle, and the groin area at the blue buckle. Take note that the two hind leg straps are located just behind the blue buckle.
Begin by unbuckling the black buckle and fitting it around your dog's neck with the buckle area on the back of the neck. If needed, adjust the strap to fit by pulling the strap through the buckle. Snap the buckle together.
The red buckle should now be at the nape of your dog's neck. Be sure that the strap attached to the red buckle is running down the back of your pet toward its hindquarters. Adjustment of the strap may be necessary.
Pull the remaining harness down the belly of your dog between the front legs. Unbuckle the blue buckle and run the fork or male end around your dog's waist and through the loop at the end of the strap attached to the red buckle. Wrap the snap or female end of the blue buckle around the other side of the dog and snap the buckle. Adjust the straps to fit snugly.
The harness should be secure around the dog's neck and groin area. Take the two remaining straps and make loops out of each of them by running the straps through the clips. Wrap these around the dog's back legs. Adjust them so they fit securely around the legs. Make sure the straps are threaded through the clip so they do not slide.
You may cut any excess strap off but remember to leave some for future adjustments. Heat the cut ends with a match to seal them.
We're sorry!
No testimonials have been submitted for this product.
 "No Jump Harness")
