Auto Lock Pet Gate System

Automatic latch and lock make this the ideal gate for high traffic areas. Easy-open latch allows rapid pass-through in either direction. Keeps your pets in designated areas. Lightweight all-aluminum construction and powder-coated finish make this a strong, long-lasting, easy-to-clean barrier. Wall mounted with 2-1/2" bar spacing. For indoor and outdoor use. Measures 26"-40" wide x 29-1/2" high. Use with one extension only. Please specify color.

Colors: Black or White.

Please click on "More Information" for care, parts, and assembly information.

Please note: If you wish to ship item 24689 by express service, additional shipping charges will apply during checkout.

Cleaning Instructions: To clean, rinse with lukewarm water, wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge. Rinse again. Dry with a soft cloth or sponge to prevent water spotting. Do not scrub with brushes or squeegees.

When used outdoors, the manufacturer suggests spraying hinge and latch parts with a marine corrosion inhibitor by CRC or equivalent. This can be obtained normally at marinas or auto parts stores. Remove set screws when separating frames for cleaning.

Parts

• Hinge Bracket
• Nylon Washer
• Key Ring
• Allen Wrench
• Latch Bracket Screws (4)
• Hinge Bracket Screws (4)
• Hinge Eye Bolts
• Jam Nut (2)
• Washers
• Hinge Rod
• Latch Assembly

Thread hex jam nut fully into hinge eye bolts, then install eye bolts with flat metal washers on top and bottom into threaded receptacles on hinge side of gate. Lower bolt is normally the best to level gate if required during installation. Always use rod or screw driver to prevent eye bolt from turning when tightening or loosening hex jam nut. Be sure jam nuts are very tight before using gate.

Installing:

1. Install hinge bracket using 3/4" Phillips screw at 5-1/2" above floor
2. Install upper bracket screw
3. Install rod through bracket and hinge bolts as shown on instruction sheet.
4. Caution: set screws can mar finish. To expand gate, loosen upper and lower set screws with Allen wrench. To prevent marring of finish, keep shipping tabs in place until final adjustment.
5. With latch in locked position, hold upright and interlock with safety bracket on gate frames. Expand gate so that latch bracket can be located on desired mounted surface. Check gate sections to ensure they are level with each other. While holding the latch in proper position on mounting surface, mark for one hole only. Remove latch from gate and mount as marked.
6. Open latch by pulling on handle and turning in direction of open gate. With set screws slightly loose, adjust gate width so that when closed, gate will engage latch yoke and safety bracket will interlock with flange of latch as shown in photo. With shipping tabs still in place, adjust gate width slightly so that when operated, safety bracket will pass inside flange of latch without touching. There should be at lease 1/2" overlap. Slight contact will not impair operation. Tighten set screws enough to hold sections firmly while checking operations of gate in both directions. When satisfied with adjustment, loosen one set screw at a time and remove shipping tab. Retighten set screws sufficiently to engage frame. For added security, install key ring in rod end.

1. Using bolts and washers included, attach extension to hinge side of gate.
2. Install hinge eye bolts in extension and follow main instructions.

Donna M
High Springs, FL

I have two of these gates. They are very sturdy, they keep two whippets and two greyhounds from entering the kitchen. I am going to install a third to keep them out of the bedroom areas, as they have learned to open the doors! I have had many friends remark at how nice they look and how well they work.

Kim S
Chicago, IL

Have two of these and I LOVE them! They were easy to install, look great, and are a breeze to open and close. Thanks for offering such a wonderful product!

Deb
[City Not Selected], KS

I just bought this gate and installed it in the kitchen doorway. It was very easy to install, and works great!! Nice product; I will be buying a couple more.