Acrylic Safe Mag-Float®

Mag-Float®? Essential tool for convenient aquarium maintenance - magnetic algae scraper scrubs away algae and film without ever getting your hands wet.

Simply drag the no-scratch, felt-lined handle, and inside your aquarium, the scrubber follows, cleaning as it goes. Better yet, if the magnets separate, the scrubber floats right back to the surface, so you'll never have to dig around on the bottom. Models available for either glass or acrylic aquariums.

Keep your Acrylic Safe Mag-Float® performing at its peak by replacing the old pad and felt. Replacement Pad/Felt contains 1 cleaner Pad and 1 Felt and is available for Medium, Large, and Extra Large Mag-Floats.

Please click on "More Information" for instructions.

1. Clean the outside aquarium surface thoroughly before each use.
2. Do NOT use Mag-Float® above waterline or on dry glass.
3. Use Mag-Float® only on aquarium material, size, and thickness of glass specified.
4. Remove all debris from the Mag-Float® prior to use.
5. Leave the Mag-Float® attached to the aquarium surface.
6. DO NOT place magnets together outside of the aquarium after its initial use, unless:
   • Magnets are completely dry. For longer durability, maintain the felt on the magnet's dry side (logo side that is placed on the exterior aquarium surface). This portion of the magnet does not float.
   • KEEP THE Mag-Float® AWAY FROM CHILDREN and electronic devices such as computers or pace makers.

Instructions on replacing the Mag-Float® Pad/Felt

Note:

• Felt is applied to the magnet that contains the Mag-Float® logo.
• Pad is applied to the magnet that does not contain the Mag-Float® logo.

Step 1
Remove old Pad/Felt entirely without damaging the plastic surface of the magnet.

Step 2
Apply mineral spirits on a cloth and rub plastic surface until all excess glue is removed (glove use recommended).

Step 3
Wait until plastic surface is completely dry before applying new Pad/Felt.

Step 4
Peel back paper backing from new Pad/Felt approximately a quarter of the way.

Step 5
Line up the new Pad/Felt with the plastic surface area of the magnet.

Step 6
Apply pressure to the Pad/Felt area that has been peeled off so it glues onto the plastic surface of the magnet.

Step 7
Apply pressure to the rest of the new Pad/Felt as you slowly remove the rest of the paper backing. This will help prevent any air bubble to be formed between the plastic surface and the Pad/Felt.