Maintain Gamma UV Sterilizer performance with replacement UV Lamps and Quartz Sleeve. The quartz glass used in the Gamma UV allows the highest transmission of UV light in the industry. This light transmission can be affected by calcium and other mineral deposits on the Quartz Sleeve.
It is recommended that the Quartz Sleeve be removed every 6 months and soaked in vinegar or any calcium/hard water stain remover to dislodge these deposits. Replace if necesarry.
The T-5 UV Lamp should be replaced every 9-10 months for maximum efficiency. Replacing the UV Lamp with Current USA brand germicidal lamp ensures the highest performance.
Please click on "More Information" for installation instructions.
The Gamma Ultraviolet Sterilizer MUST be plugged into a ground fault circuit interrupter (GFCI) outlet at all times. Do not operate the UV Lamp without water flow. Overheating may occur to the lamp or Gamma UV Sterilizer body. Inspect the unit once a month for any damage due to corrosion. Remove from service if damage is found.
Once the Gamma UV Sterilizer is assembled, it is strongly recommended that you "water test" the unit. Observe initial operation for a minimum of 30 minutes to ensure the unit is running properly and there are no leaks. At no point should you look directly at the uninstalled UV Lamp while it is lit. Serious eye damage can occur. The clear threaded viewing sections on the UV Body will indicate whether the lamp is working once the Lamp is installed.