Zoo Med Reptibreeze Reptile Cages

Spacious reptile cages are made completely of aluminum screen sides to supply your pet with maximum ventilation. Open-air design is ideal for small species of old world chameleons, juvenile green iguanas and other arboreal lizards, such as geckos and anoles. Breezy, lightweight construction lets you easily move cage outdoors for increased UV exposure and fresh air. Large swing-open front door gives you plenty of inside access to tend to cage maintenance and pet needs. The convenient flip-up bottom front door allows you to easily remove or change substrate. Made with a corrosion-resistant, black anodized aluminum frame. Available in three spacious sizes to suit your particular reptile species. Easy assembly.

Please click on "More Information" for assembly instructions.

• Your new Repti Breeze Screen Cage includes the following components:
• Six panels with screen mesh (top, back, right and left sides, upper main door, and lower door)
• One bottom panel (no screen mesh)
• Floor insert
• Four short screws for attaching hinges
• Longer screws for attaching panels

Tools Required:
Phillips screwdriver

Assembly Tips

• Prior to assembly, check to make sure that there are no missing pieces.
• Do not over-tighten the screws to avoid stripping the holes in the cage.
• For ease of assembly, assemble the panels in the order listed below. Be sure to match up the corresponding letters for each panel during assembly.

Assembly

1. Attach top panel to back panel: Place the back panel on its long edge. Locate the edges labeled "C" on both the back and top panels. Attach the top panel to the back panel to the back panel using two long screws. Note: The panel label stickers should face "out" for the cage for all screen panels (except the bottom panel) as shown in the photos.
2. Attach bottom panel to back panel: Align the letters "K" on the bottom and back panels. Screw the panels together using long screws. Note: The panel label stickers on the bottom panel should face inside the cage. Label stickers on all other panels face outside.
3. Attach the right side panel: Match letters "D, F, and J" on the right side panel to the corresponding letters on the top, back, and bottom panels. Use long screws to attach panels together.
4. Insert lower door hinge pin and attach left side panel: Turn the assembly over so that it is resting on the right side panel. Locate the hole for the bottom door hinge pin on the inside edge of the right side panel. Align the "I" label on the bottom door with the corresponding label on the bottom panel (sticker must face out). insert the right bottom door hinge pin into the hole on the right side panel. White holding the bottom door in place, set the left side panel on the assembly, making sure that the left bottom door hinge pin goes into the hold in the inside edge of the left side panel. Attach the left side panel using long screws. Shut the bottom door and rotate latches on either side to lock.
5. Attach upper main door: Turn the assembly into the back panel and set the upper main door in place by matching the labels "A, H, and E." Use the four short screws to attach the hinges to the right side panel.
6. Insert floor panel: At this time, you may remove the panel identification labels. Place the terrarium upright and insert the floor panel through the upper main door as shown. Shut the upper main door and lock it by rotating the latches, making sure that the latch pegs on the door fit into the recesses in the latches. Your Repti Breeze is now assembled and ready to use.