Cobalt Aquatics Neo-Therm Heater: Submersible Aquatic Reptile Heaters

*	Hi-tech shatterproof and submersible heater for aquatic reptile habitats

*	Accurately maintains water temperature essential for reptile wellbeing

*	Thermal protection circuitry and audible alarm ensure reptile safety

Electronic heater for aquatic reptiles designed for safe, simple and accurate water temperature control. Cobalt Aquatics Neo-Therm Heater features advanced thermal protection circuitry and an audible alarm that sounds when temperatures rise above the set point. Temperature setting from 66°F to 96°F is accomplished with easy to set "one touch" system. Shatterproof, European-made heater simultaneously displays set temperature AND aquarium water temperature with LEDs for fast, visual confirmation.

Cobalt Aquatics Neo-Therm Heater features a flat, narrow design to provide precise heating while blending in discreetly with the décor of aquatic reptile habitats, paludariums, turtle tanks and aquatic herptile terrariums. Stylish, shatterproof exterior conceals a sophisticated electronic microprocessor thermostat to ensure water temperatures accurate within ±0.5°F. Cobalt Aquatics Neo-Therm Heater includes suction-cup mounts and measures only 2" x 1"!

Terrariums up to	Watts	Length
6 gallons	25W	6-1/2"
12 gallons	50W	6-1/2"
20 gallons	75W	6-1/2"
29 gallons	100W	9-3/4"
40 gallons	150W	10-7/8"
55 gallons	200W	10-7/8"
70 gallons	200W + 50W	NA
80 gallons	200W + 100W	NA
125 gallons	200W + 200W	NA

Downloadable Neo-Therm Heater Manual PDF.
(Requires Adobe Acrobat Reader 4.0 or later - get it here for free)

Shop all Submersible Heaters for Reptiles.

Please click on "More Information" for direction for use.

Cobalt Aquatics Neo-Therm Heater

Important: Do not plug in heater until instructed.

Attach the suction cup (included) to the Mounting Bracket. Slide bracket over heater to position indicated.
Place Neo-Therm Heater in aquatic terrarium by firmly pressing suction ends against wall surface. This ensures even heat distribution and optimum operation. No part of the heater housing should contact aquatic terrarium gravel, rocks or decorations.
Wait at least 15 minutes before plugging in your heater. When first plugged in, the LEDs will circle and then stop and will display the set temperature with a solid LED and the tank temperature with a blinking LED. A slow blinking LED indicates tank temperature is below the set temperature. A fast blinking LED indicates tank temperature is above the set temperature. Single solid LED show tank and set temperatures are at the same point. Note: Before plugging in heater, create a drip loop to prevent water from reaching electrical receptacle.
Select the desired temperature. Press button on top of heater. Each push will increase tank temperature by 2°F. When adjusting temperature, only one LED will be lit and will move from temperature to temperature with each push. When desired temperature is reached, wait a few seconds and LEDs will circle and stop on the new set temperature and display tank temperature. If you would like to lower the temperature, push button until temperature reaches maximum and with the next push, the temperature will cycle to lowest temp again. Keep pushing button until you reach desired temperature.