Easy Pro Mag-Drive Pumps

Quiet, energy-efficient magnetic drive pumps at a great price. Versatile, high performance pumps boast power and low energy use - ideal for pond fountains and waterfalls. Washable pre-filter and free fountain set* included with Models EP600-EP1350. Larger pumps have screened inlet. Submersible use only. Limited 3-year manufacturer warranty (2-year warranty for Models EP4700 & EP6700; 1-year warranty for Model EP9700).

* Fountain set for EP600 & EP850 include Volcano, Water Bell & Double Volcano spray pattern, EP1350 includes Volcano, Water Bell, Double Volcano & Foaming Jet spray pattern.

Downloadable Easy Pro Mag-Drive Pump Instructions PDF.
(Requires Adobe Acrobat Reader 4.0 or later - get it here for free)

Please click on "More Information" for operation details and safety tips.

1. Pump and filter must be fully submerged underwater to prevent pump from sucking air. All pump models greater than EP 3200 can also be used as an external pump. Remove the filter housing and filter from pump and connect suction hose to intake side of pump to use as an external pump.
2. The pump should be cleaned regularly, loss of output will result if filter becomes too dirty.
3. If the pump is powering an undergravel filter, make sure the gravel is clean to produce a good flow.
4. Clean the impeller when the pump flow is visibly reduced. The impeller is located inside the pump housing. It can be accessed by holding the pump body, rotating the impeller cover and pulling the pump cover away from the main body.
5. When disassembling the impeller, do not lose the small plastic washers positioned at the top and bottom of impeller. These washers are critical to the quiet and efficient operation of the pump.
6. Clean the impeller in fresh water and clean the housing by using cotton swabs (or similar) to remove all of the accumulated debris from the pump.
7. The power cord should be extended to below the power outlet to prevent water from dripping down the cord and into the outlet.
8. You must use a ground fault circuit breaker with this pump.

Safety

• Make sure the power supply is 110v AC, correctly fused and grounded.
• Never let the pump run without water in the pump chamber - this will damage the impeller, overheat the pump and possibly burn out the electric coil.
• If you need to drain your water feature or change water, disconnect the pump before draining the water.
• Never let the water level in your water feature fall below the top of the pump body.
• Do not use this product in bathrooms or swimming pools.
• Do not use this product if the power cord becomes damaged, swollen or cracked.
• If the pump is noisy, replace the impeller as this is a wearable part.
• If your pump is not pumping water out, turn off the power and investigate the reason for the problem. Possible causes are dirty filter, broken impeller, or dirty impeller housing.

Manufacturer's Warranty
This product is warranted against any mechanical or material defects for a period of three years from the date of purchase (impellers are a wear item and are not covered by warranty). Warranty does not cover accidental damage to the product due to abuse or negligence by consumer.

In the event of a warranty claim, please return the pump postage prepaid with the original receipt for repair or exchange. No warranty claims will be honored without the original receipt.

See package insert for warranty exclusions and other instructions.