Submergible Pond De-Icer with Guard

Hidden from view and perfect for small ponds. Thermostatically controlled, economically priced, submergible de-icer gets the job done. Unit sinks to remain virtually invisible. Automatically turns on at 35ºF to keep small ponds free of ice. Protective, 10 ft. cord included. One-year manufacturer warranty. 1500 watts. For smaller ponds up to 600 gallons. 13" diameter. UL-Listed.

Thermostatically control your De-Icer with a Thermo-Cube.

Please click on "More Information" for specifications.

• Thermostatically controlled
• 1500 Watts of power
• 1-year guarantee
• Epoxy-sealed; no leaks, no shorts
• Fish- and plant-friendly
• For ponds up to 600 gallons

About your Pond De-Icer:

• The Submersible Pond De-Icer is designed to keep open a vent hole in the ice to release harmful gases from underneath. Even the smallest of holes will suffice. If you allow your pond to completely freeze over during the winter months, the harmful gases produced by fish waste and plant decay cannot escape the ice. These trapped gases eventually build up to levels which are deadly for your costly fish and plants.
• The Submersible Pond De-Icer is intended for use in ponds of 600 gallons or less. A pond larger than 600 gallons will require the use of two de-icers tied together to act as one.
• Place your de-icer at the edge of your pond, touching the liner, in the shallowest area. This placement will allow the unit to operate more efficiently by reflecting heat off the side of the pond or liner.
• DO NOT drag your submergible de-icer along the bottom of your pond, as it may snag and damage the liner.
• Your de-icer must be protected from the wind. The wind steals heat faster than the unit can release it. If not protected from the wind, your de-icer will not function to its fullest capabilities. To set up a wind barrier, place a sheet of plywood so it covers the corner of the pond with the de-icer positioned underneath it. Be careful not to completely cover the pond, or toxic gases will not be able to escape.
• Keep your de-icer heating element free of mineral buildup, such as lime. Lime buildup is the leading cause of de-icer failure and will void the warranty if the unit is not properly cleaned and maintained. To remove lime buildup, clean your de-icer with white vinegar or a commercial lime-removing cleanser and a brush. Keep your de-icer clean for maximum efficiency and longevity.
• Monitor your power supply. Low power, extension cords, or defective housing wires will greatly reduce the effectiveness of your de-icer. DO NOT use extension cords with your pond de-icer.
• DO NOT ASSUME YOUR DE-ICER IS DEFECTIVE IF IT SHOULD NOT PERFORM TO YOUR EXPECTATIONS. To determine if your de-icer is truly defective, you must perform an "air test." Place the de-icer in the freezer or outside (if the temperature is below 35 degrees F) for one hour (the unit should not be in water). After an hour, plug the unit into a known good outlet. Hold the unit by the supply cord. Within seconds, the element should begin to heat. After a few minutes, unplug the unit and let it cool. If the de-icer performs as specified above, it is working fine and to its fullest capacity.