Hanging Arm Assembly for Current-USA Light Fixtures

Enjoy a stylish and convenient way to hang your Current-USA light fixture over your aquarium. Innovative Hanging Arm Assembly secures onto flat-back aquarium stands with included hardware for easy installation. Eliminate the need to locate load-bearing, wood ceiling beams and other installation challenges associated with conventional wire hanging kits. Metal arms measure 48" high total (44" high from the top of mounting hole) and 12" wide (from center screw hole to inside back of arm).

Compatible with Sunpod, Outer Orbit HQI, SunDial HQI, and Nova Extreme Pro aquarium light fixtures.

Please click on "More Information" for safety instructions.

• If an electrical appliance falls into the water or water drips onto the electronics, DO NOT reach for it! First unplug it and then retrieve it. If electrical components of the appliance get wet, unplug the appliance immediately.
• Always unplug appliance from an outlet when not in use, before putting on or taking off parts, and before cleaning. Never yank cord to pull plug from outlet. Grasp the plug fully and pull out to disconnect.
• Carefully examine the fixture after installation. It should not be plugged in if there is water on parts not intended to be wet.
• Do not operate fixture if it has a damaged cord or plug or if it is malfunctioning or damaged in any manner.
• If the plug or receptacle gets wet, do not unplug the cord. Disconnect the fuse or circuit breaker that supplies power to the fixture. Then, unplug and examine for presence of water in the receptacle.
• Close supervision is necessary when any appliance is used by or near children.
• To avoid injury, do not contact hot parts such as lamps and the like.
• Always unplug the fixture from an outlet when not in use, before putting on or taking off parts, and before cleaning. Never yank cord to pull plug from outlet. Grasp the plug and pull to disconnect.
• Do not use the fixture for other than intended use. The use of attachments not recommended or sold by the manufacturer may cause an unsafe condition.
• Do not install or store the fixture where it will be exposed to the weather or to temperatures below freezing.
• Make sure the fixture is securely installed before operating it.
• Read and observe all the important notices on the fixture.
• If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less Amperes or watts than the fixture rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.