Heavy-duty steel pet gate withstands tough chewers at a great bargain price. Durable screw in pressure mounted gate stays firmly in place. Protective wall cups with screw in pressure mounts secure gate. A 17" x 30" high swinging door with easy-lift locking handle opens one way. Small door in door (7.5" x 10" high) allows smaller pets like cats to pass through. Includes one 6" x 30" high and one 12" x 30" high extension to accommodate openings 29" to 52" wide. 2.25" bar spacing. 4.5" long adjustable pressure mounts. Extra extension panels sold separately for wider openings. Please specify color: White, Black, or Platinum.
Please click on "More Information" for assembly and installation instructions.
Assembly and Installation Instructions|
Pre-Installation: Please check to see all parts are present before assembly.
Insert the assembled Threaded Spindle Rods and Hand Wheels into the appropriate holes in the plastic end plugs at the top and bottom of the Gate. NOTE: Plastic plugs are NOT threaded. They are only guides for the Threaded Spindle Rods.
Place a Wall Cup over each Spindle Rod. Turn the bottom Hand Wheel to extend the adjustable Spindle Rod until the base is held firmly in position. Continue tightening the Hand Wheel until the gaps on either side of the Gate are as even as possible.
Turn the top Hand Wheels to extend the adjustable Spindle Rod. Continue turning the Hand Wheels to reduce the gap between the handle and the side rails. The Gate is properly positioned when the gap between the handle and the side rails is approximately 1/16".
Important: It is essential to position the Gate as vertical as possible so that the Gate can close and lock properly before marking the position of the Wall Cups. Adjust or reposition as needed.
Securing the Gate in Place
Using the Attachment Screws provided, secure the Wall Cups in their marked position. The Attachment Screws are suitable for a minimum wood thickness of 3/4". For all other surfaces, use an appropriate, secure method of attaching the Wall Cups.
Replace the Gate inside the attached Wall Cups. Turn the bottom Hand Wheels until the base is firmly held into position. Once again, make sure the gaps on either side of the Gate are as evenly spaced as possible.
Turn the top Hand Wheels towards the Gate frame until the gap between the handle and the side rails is about 1/16". Do not over-tighten since it may prevent the locking mechanisms from functioning.
Once installed, make sure the Gate is properly installed and secure.
Using the Gate:
Gate Extension Assembly Instructions
Installation Tips (Supplement to Instructions)
Helpful Hint: Occasionally, while turning the adjustable Hand Wheel, the flat plastic end of the Threaded Spindle Rod will start turning inside the Wall Cup. If this occurs, simply take a flat-ended screwdriver and press it against the flat plastic end of the Threaded Spindle Rod while turning the adjustable Hand Wheel.