Indoor/Outdoor Heated Pad

Thermostatically controlled design offers warmth only where pet lies. Energy efficient technology doesn't heat the entire surface of the bed. Tough exterior protects inner orthopedic pad. Wipes clean. Includes cover. 5.5 ft steel wrapped chew-resistant MET-Listed cord.

See all our Heated Cat Beds.

Please click on "More Information" for use instructions.

1. Place directly on a hard, flat surface. Area chosen should be a sheltered area out of direct rain or snow.
2. Pull out the air valve on the bottom side of the bed. Plug into 110-120 volt AC outlet while the air valve is still released. Allow 15 to 30 minutes for the Lectro-Soft to begin to warm and fully expand. The unit will feel slightly warm to the touch. After desired expansion, push down on the center of the bed to remove a little air. Then push the air plug in to seal the bed. This will ensure against "ballooning" when your pet is enjoying the bed. The built in thermostat will automatically regulate the temperature.
3. After initial warm-up, your Lectro-Soft will feel cooler to the touch. This is the intension for energy efficiency. When your pet lies upon the bed, it will warm to a cozy, pet pleasing temperature even in the coldest of weather.
4. Testing your Lectro-Soft bed. Place a blanket, pillow or other insulating object over part of your Lectro-Soft bed. After a few minutes, place your hand under the insulating object to experience the warmth your pet will enjoy.
5. Cleaning. Your Lectro-Soft bed may be wiped down with a damp cloth when unplugged. The unit may be plugged back in for use when thoroughly dry.
6. To store your Lectro-Soft bed, unplug, clean, and store pad when not in use.

1. Read all instructions.
2. To protect against electrical hazards, DO NOT immerse cord, plug, or appliance in water or other liquid.
3. Close supervision is necessary when used by or near children.
4. ALWAYS unplug from outlet when not in use.
5. DO NOT operate any electrical appliance with a damaged cord or plug, or if the appliance malfunctions or has been damaged in any matter. RETURN all malfunctioning appliances to the factory for examination.
6. DO NOT use appliance for other than its intended use.
7. DO NOT PUNCTURE PAD FOR ANY REASON.
8. For use with 110-120 volt AC ONLY.
9. DO NOT cover your Lectro-Soft with blankets or materials other than a fleece K&H Lectro-Soft cover. Other coverings may not allow heat to radiate properly and could cause pad failure.
10. When placing the pad in an enclosed area, be sure pad covers no more than half of the floor space so your pet has the option of sleeping on or off the Lectro-Soft heated pet bed.